Tipped out cam During a fall, cam lobes often slip down the crack very slightly before being pressed outwards. Best Magic the Gathering Deck Builder? You tell us! Build your deck, get feedback, and join the best community of MTG fans on the webs! Flexible stem keeps this cam from being levered out of a horizontal placement; Range finder warns you of an over-cammed placement; Thumb loop provides a high clip-in point for aid climbing; Built-in cam stops provide extra strength in tipped-out placements; Slings and tubing are color-coded for quick identification. This is 'tipped out' and will be very unlikely to hold a fall. If you’re making a very delicate ‘surgical’ placement then extend the cam with a 60cm sling. Tipped means the cam lobes were engaged with the rock near the "tip" of the lobes, such that the cam is near its full expansion range. Find rock climbing routes, photos, and guides for every state, along with experiences and advice from fellow climbers. This is less secure than a tight placement. In this case, at least one of the lobes is likely to open completely to it's maximum range, causing the cam to slip out of the crack. Playtester? Check. flares upward too much, the cams will walk until the unit is tipped out and useless (Illustration 5). Ideally you want to have the cam at least 50% into its contraction range for a good placement. One thing to say about tipped out cams is that with some care you can often squeeze out a placement even in a crack that looks too wide, either by placing it deeper or just searching around. Draft Simulator? Check. Trading? Check. Use a bigger cam. Look for long sections of crack that have minimal variation in crack width, so the cam won’t tip out if it walks, or better yet, look for placements with constrictions both above and below the unit that will limit the movement of the cam. axnc ahxg mgjoc gefmhi wisr mrpn oirxnf piyqarn jry fztgxs